×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Unity Fail-over requirements

Unanswered Question
Jan 18th, 2002
User Badges:
  • Bronze, 100 points or more

I am reading the documentation on Cisco Unity 3.12 as we speak, here are my questions on the Fail-over solution:<br><br>1) In terms of hardware, (i know if sounds kind of dumb), but can we have different memory sizes/processor speed/drive capacity on a fail-over server? <br>2) Customer will upgrade from 3.02 single server to 3.1x dual/fail-over server(s). I don't think there should be an issue going from 3.02 to 3.1x on a single server, but how do the 2 Unity server share the database information between each other after they are upgraded? Does the Failoverconfig.exe process take care of this?<br><br><br>Systems Engineer

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Thu, 01/24/2002 - 05:30
User Badges:

There sould not be a problem with one.

2) The process will be to upgrade server one from 3.02 to 3.12, then Install your second server with 3.12
Then run the failover config on the SECOND server. This will make a connection to the first server. Then run the failover config on the First server. and this will remove extra user accounts (i.e. the second example administrator, etc) from the second server. And you should be good to go.

Actions

This Discussion