×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
t.muschak Wed, 01/30/2002 - 01:34
User Badges:

Hi Kostas,

You cannot configure it per VC.

You only can actrivate VC shaping per line.

If enabled, all new PVCs terminating to this line/port have VC shaping enabled.

To activate it on all existing PVCs, you either have to reset the card or down/up the connection.

Afterwards, you are not able to check on what PVC the VC shaping ios already enabled.

Hope this helps.


Rgds,

Thoralf Muschak

Actions

This Discussion