Limiting Bandwidth

Unanswered Question
Jan 28th, 2002
User Badges:

I have a Cisco 2620 router (connected to a T1). I want to be able to limit the bandwidth useage based on an IP address of a user inside my network. I researched CAR (committed access rate) but found out that it only works with the 7xxx series. Any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
beth-martin Mon, 02/04/2002 - 07:34
User Badges:
  • Bronze, 100 points or more

CAR is an IOS feature available from Cisco for your 2600. I ran it on feature navigator (www.cisco.com/go/fn) and it shows support since 12.0.(1)T. You’ll need to contact your Cisco rep for a software upgrade.

ramesh.krishnan Mon, 02/11/2002 - 10:11
User Badges:

hi,


for limiting a user's bandwidth you can use the rate-limit comand.


For limiting by IP..u create a extended access-list say 110


then to your gateway interface you can put rate limit

like


rate-limit input access-group 110 60000 10000 10000 conform-action transmit exceed-action drop

The above ids to limit his input..now substitute ipput with output to limit his output.


Thanks,


Ramesh



Actions

This Discussion