Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
225
Views
0
Helpful
1
Replies

Upgrading 6509

sknorr
Level 1
Level 1

‎02-22-2002 06:23 AM - edited ‎03-01-2019 08:35 PM

Hi,

After I load the new image into Bootflash, do I have to do a full reset or can I just reset module 1.

Thanks,

Steve

Labels:
0 Helpful
1 Reply 1

khaile
Level 1
Level 1

‎02-22-2002 06:34 AM

Hi there,

Check the config if you have the following lines

#set boot command

set boot config-register 0x2

set boot system flash bootflash:cat6000-sup.X-X-X.bin

(X=to the ver number such as, 5-5-5) then you can apply reset. Be sure if you have standby sup it should need to syncronize first. Good luck

0 Helpful
Customers Also Viewed These Support Documents