×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco 2611 with NM-32A

Unanswered Question
Mar 1st, 2002
User Badges:

Not sure where to post this. Anyway, a customer has a Cisco 2611 and an NM-32A module. They're using this configuration as a terminal server. They're using SSH to access the unix servers attached to the terminal server. They're saying that only 4 concurrent users can access the ports via SSH. They'd like to know whether it would be possible to have more than that...maybe even 32 concurrent users...one user per port via SSH.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ciscomoderator Thu, 03/07/2002 - 12:16
User Badges:
  • Gold, 750 points or more

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen


If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.


Actions

This Discussion