×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
wdrootz Mon, 03/11/2002 - 15:08
User Badges:
  • Bronze, 100 points or more

2.12 (or higher) supports g.729a the best (there were some bugs in 2.11) but I’m almost positive you can’t select any other port than 0 (Check with Cisco to be sure). Settings are: LBRCodec: 3, LBRCodec: 3, RxCodec: 3, TxCodec: 3, AudioMode: 0x00140014

dschapov Mon, 03/11/2002 - 20:09
User Badges:

Do you mean h323/sip software ? I know, how change g.729 capable port in this software, but I was asking about MGCP/SCCP software.



wdrootz Wed, 03/13/2002 - 07:05
User Badges:
  • Bronze, 100 points or more

I couldn’t find anything in the docs on that. You’ll prob have to check with Cisco on that.

Actions

This Discussion