Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
343
Views
0
Helpful
3
Replies

ATA186, SCCP - select port g.729a capable

dschapov
Level 1
Level 1

‎03-05-2002 12:19 AM - edited ‎03-12-2019 02:41 PM

Hi.

How can I select port on ATA186, which can use g.729 codec. By default it's port 0. Bit 21 is used only in MGCP mode.

Thanks.

Labels:
0 Helpful
3 Replies 3

wdrootz
Level 4
Level 4

‎03-11-2002 03:08 PM

2.12 (or higher) supports g.729a the best (there were some bugs in 2.11) but I’m almost positive you can’t select any other port than 0 (Check with Cisco to be sure). Settings are: LBRCodec: 3, LBRCodec: 3, RxCodec: 3, TxCodec: 3, AudioMode: 0x00140014

0 Helpful

dschapov
Level 1
Level 1
In response to wdrootz

‎03-11-2002 08:09 PM

Do you mean h323/sip software ? I know, how change g.729 capable port in this software, but I was asking about MGCP/SCCP software.

0 Helpful

wdrootz
Level 4
Level 4
In response to dschapov

‎03-13-2002 07:05 AM

I couldn’t find anything in the docs on that. You’ll prob have to check with Cisco on that.

0 Helpful
Customers Also Viewed These Support Documents