×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Tacacs+/Ciscosecure and ISDN

Unanswered Question

Could someone tell me what is the difference between a dial-up user and an ISDN backup locations set up to authenticate with Ciscosecure through a Tacacs+ server? All the dial-ins and ISDN are set up the same(problem) dial ins are ok ISDN fails. Using Chap and have secret passwords same, host and remote names are opposite etc. Any Ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
zahmed Sun, 03/17/2002 - 19:54
User Badges:
  • Cisco Employee,

Your config needs to be looked at before going into debugging level, specially the config of the

dialer interface (s) to which the backup location(s) dial. You might want to open up a TAC case too.


~Zulfi

Actions

This Discussion