03-19-2002 07:44 AM - edited 03-08-2019 10:06 PM
hi
i have a 4220 configured on 3.0 5 s18 with cspm 2.3.3i
i have put all high options to log enable and if i tryx to simulate a attack nothing appears !!
sensing was to auto
after i have put to IPRB0 no chages ...
any idea why ? thanks for your reply
philippe
03-26-2002 09:26 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-04-2002 07:35 PM
has be done open a tac case
thnaks for your helps
phil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide