03-21-2002 01:22 AM - edited 03-01-2019 08:57 PM
A question that has been asked many times before ;-
If I had two remote sites A & B. There are two WAN serial conenctions (10Mbps)between each site. Each terminating on its own router.
Site A Site B
----- wan -----
-|--- | R1A |....................| R1B |----|-
| ----- ----- |
Eth | |Eth
| ----- wan ----- |
-|--- | R2A |....................| R2B |----|-
----- -----
What is the best way to utilise all WAN bandwidths (2 x 10Mbps). I dont really what to use 2 HSRP groups at each site, as this would involve modifing host default gateways.
Is Policy routing the only other option I have ?
03-21-2002 01:24 AM
Sorry about the diagram, spaces didnt work !
03-21-2002 05:47 AM
I havent tested this but I think you could put 2 static routes in R1B for example that points to R2B and R1A with the same admin distance and this should load balance over the two routers. You would ofcourse have to do this at the other side of the link. Bit more involved than this but I hope this is clear.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide