×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Reset a controller to the factory defaults

Unanswered Question
Apr 1st, 2002
User Badges:

Hi,


How do I reset a controller to the factory defaults?


At the config mode I issue a "default interface <interface-name>" and

I could reset the interface to defaults.


I do the same for controller (default controller <controller-name>)

and I get the message "% Cannot remove controllers this way"

Not giving up, I deleted the channel-groups under that and did the same. No

difference in the error I got.


Any magical command to do what I achieved for the interface?


regards,

Sathya


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Mon, 04/01/2002 - 21:13
User Badges:
  • Cisco Employee,

There is no way to do some sort of "reset controller"..You need take the config commands out from the controller, one by one.Once there are no commands, its as good as factory default.


Once the controller is in the router, it works as physical interface and you can't remove the physical interface by typing "no" in front of it..By the way why you want to reset it?...Tejal

Actions

This Discussion