×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Netconfig: job fails with status missed start

Unanswered Question
Apr 1st, 2002
User Badges:

I am runnning CW2000 4th Edition (RME 3.3) I'm unable to get Netconfig to run a job. The job I'm trying to run is to add a banner (MOTD) to a Cisco switch (IOS). I select immediate excution and hit finish. At this point the job browser appears and shows that the job is scheduled. In the Run Status column, I see the status change from "Missed Start" to "Start Failed". There is no other detail.


I found some troubleshooting info on netconfig on CCO but it does not address this problem. Any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rmushtaq Mon, 04/01/2002 - 11:39
User Badges:
  • Blue, 1500 points or more

Try doing a CCO Bug Tookit search for this. There were some issues with banner (motd) downloads using NetConfig like special characters etc.

Actions

This Discussion