×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Best way to connect two 2610's? Via PVC

Unanswered Question
scarothe Mon, 04/08/2002 - 09:28
User Badges:

Greetings:


Doesn't matter whether you do that or IP unnumbered. Will function the same.



Thanks...Steve

Thats cool.

I want to set both offices up as if they are in the same location. I want both to pick up IP's from the DHCP in building 1 etc. Basically the routers are in place but I want them to be invisible, so the users in building have exactly the same resources etc as the users in building one...

any ideas?


TIA

nuno.morais Tue, 04/09/2002 - 02:33
User Badges:

Hi.


If you want both offices to share the same subnet, you may want to use some form of bridging... You may also need DLSW+ between the routers.


Hope this helps.


NM

tmoreo Sat, 04/13/2002 - 09:40
User Badges:

If all you want is for a central site to give DHCP to a remote site for centralized administration try using the "IP helper" command.

Actions

This Discussion