Telnet Response

Unanswered Question
Apr 26th, 2002
User Badges:

i have a 5505 at a remote site that seems to have a possible problem (though not affecting production). when i log into the 5505, via telnet, the password prompt comes up immediately... then, when i enter the password i don't get the next response for about 30 seconds. also, when i do a "show ip route" i also get a very long delay.

no errors are logging, memory is fine and people are not complaining... just don't understand what's causing the problem.. AND if I telnet to the switch hanging off the 5505 - i have no problems.... thoughts?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paumercier Fri, 04/26/2002 - 10:09
User Badges:


I came across the same behavior some time back and found that if dns was setup and enabled the behavior was resolved. Give it a try and let us know.

set ip dns server "your.dns.server.ip" primary

set ip dns server "a.secondary.dns.ip"

set ip dns enable

set ip dns domain "your.domain"



russell-r Fri, 04/26/2002 - 10:29
User Badges:


thanks for the response. I have dns setup and all statements mentioned above are present within the config... strange problem...


This Discussion