×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Symbol VoIP Phones Working with Cisco

Unanswered Question
Apr 29th, 2002
User Badges:

Has anyone been successful at integrating a Symbol NetVision VoIp phone with a 1751 (with FXO cards) or a VG200 (with FXO cards)? The connection, through a standard PBX line, will last only 20 seconds befofe the call terminates. It seems like the Symbol phone is dropping the call. Any help would be appreciated..

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paul.harrison Fri, 05/03/2002 - 05:51
User Badges:
  • Bronze, 100 points or more

Larry,


Why do it the hard way?? Get your netvision phone re-configured with Skinny protocol and it the appears to the call manager as an SP12+, much easier than trying to use a gateway and you get the added benefits of Call Manager features (pick-up, names etc.).


The gateway method sucks, do it the better way. If you got the phone direct from Symbol and they knew you were connecting them to CM then the rep wants shooting (US people this is an expression and not an instruction). If you've had them a while then they may pass on a small charge for the new protocol on the phone.


Paul

Actions

This Discussion