×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Can I use LS1010 as Mux to send Timeslots from an E1 as VCs on an STM-1

Unanswered Question
May 8th, 2002
User Badges:

We have PSTN C7 signalling arriving in a PoP in timeslots in TDM E1s (2 timeslots per E1). We need to get them to another location and have an STM-1 link. Can we use Circuit Emulation E1 cards and send just the signalling timeslots over VCs on the STM-1?

Also, at the other end, can we demux the signalling timeslots back to CE E1s (probably in a more concentrated form than originally - more than 2 timeslots per E1).

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ciscomoderator Wed, 05/15/2002 - 11:19
User Badges:
  • Gold, 750 points or more

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml


If anyone else in the forum has some advice, please reply to this thread.


Thank you for posting.


Actions

This Discussion