×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Gatekeeper endpoint timeouts

Unanswered Question
May 8th, 2002
User Badges:

Hi There, I am curious where or if I can set a timeout on end points that register with the gatekeeper, or if I can manually unregister an endpoint.

I have an ios 3640 gatekeeper in a dynamic ip environment. If the lease times out on the host, the gatekeeper does not release the ip. The host then tries to re-register with the gatekeeper with the new ip. The gatekeeper blocks the request because it still has the same cached username and the last ip of the host before the lease timed out.

I get a "name already exists, please use a different username" error.

Any idea's or suggestions would be greatly appreciated!

Thanks

Chris

Network admin

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sachon Wed, 05/08/2002 - 19:33
User Badges:

The IOS GK allows youto set a ttl value for registrations. By default I believe this is set to 60 minutes. So if an H.323 terminal were to disconnect from a network without sending a DRQ to the GK, the entry would exist through the remainder of the default ttl. It is recommended you change the ttl value to 60 seconds and this should solve the problem you're seeing.

aglowack Thu, 05/09/2002 - 14:56
User Badges:
  • Cisco Employee,

This is true, however you will need a minimum code rev of 12.1(5)XM, I don't think the T train has the endpoint ttl command....

Actions

This Discussion