cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
219
Views
0
Helpful
1
Replies

ATM SNMP traps

todd.j.sharp
Level 1
Level 1

I am having trouble getting my 7206 routers to send traps when an ATM pvc changes status. ILMI doesn't work with the Ascend switches that they are connected to, so I'm using OAM-PVC management on the routers. I have snmp traps enabled on the routers with the following line:

snmp-server enable traps atm pvc interval 40 fail-interval 10

Manually toggling a subinterface down on the far end doesn't seem to trigger an alarm even though I see the pvc status change on the near end.

Any suggestions appreciated..

1 Reply 1
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco