×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Need help designing a system

Unanswered Question

I need help. We are trying yo impliment a wireless pick and ship system in our Distribution wherehouse. The system has been purchased and installed, but we are affraid to connect it to our network due to security concerns. The system is SYMBOL brand PDT7500s and their Access points. We have a number of Cisco brand components in our wirecloset. They are the Catalyst 2948, 2980g, and 3640 router. I have a VISIO drawing of the system that I would love to share with you but not the rest of the world.


Lee

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
blue.modal Wed, 05/22/2002 - 08:15
User Badges:

Steps to take:

1. Use the SSIDs, MAC filters and 128-bit WEP keys on all devices - preferably with LEAP to rotate keys as often as possible.

2. Create a new, isolated VLAN with a separate IP subnet. All APs will connect to the new VLAN only. Use static addresses for the APs.

3. Connect the isolated VLAN/subnet through a firewall to the rest of the network. This will allow you to set separate policies.

4. Install a network management package, and possible an Intrusion Detection System to monitor traffic on the new VLAN/subnet and the firewall port.

5. If the end-user devices allow it, add a VPN.


Matthew Wheeler

Blue Modal

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode