×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

"CIP microcode not found" error message during bootup of C7507

Unanswered Question

On Cisco 7507 router during installation of new CIP microcode (CIP-27-21.bin) we have encountered a problem. During router restart we received information on the console "CIP microcode not found" (unfortunatelly we do not have logs from that day). After that we had problems with channel interfaces (it didn't go up). Then we downgraded CIP microcode (to previous ver. 27-7), but there still was the error message (the same as before). But we were able to bring up channel interfaces. We're not sure if the error message during start of Cisco 7507 router is a normal behaviour (?). Maybe the router first must load IOS to properly load CIP microcode - but then what for is the error message?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion