×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Error in firmware upgrade

Unanswered Question
Jun 21st, 2002
User Badges:

I was upgradeing the firmware in an access point and it failed halfway through. Now I get the following error message. Failed to start driver for port "awc0" (errno=0x006d0002). Is there a way to fix this without sending back to the factory?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Fri, 06/21/2002 - 18:34
User Badges:
  • Cisco Employee,

The AWCO message occurs when the radio can't be configured.

Let us know which firmware was Access Point was already on and which one you are trying to upgrade to ???

Here is a link which discuss step by step procedure for upgrading firmware for Access Points thru console port..See if that helps..

http://www.cisco.com/warp/public/102/wlan/ap-fw-upgrade.html

Thanks..Tejal


Actions

This Discussion