×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

how to block incoming call

Unanswered Question
Jun 24th, 2002
User Badges:
  • Bronze, 100 points or more

We use AS5300 for VoIP with ISDN signalling.

We want to block incoming call (call from PSTN to AS5300) and allow outgoing call (call from AS5300 to PSTN).

What should we add in our configuration?

Here is our config:

controller E1 1

pri-group timeslots 1-31

!

controller E1 2

pri-group timeslots 1-31

interface Serial1:15

no ip address

isdn switch-type primary-net5

isdn incoming-voice modem

isdn T310 60000

no cdp enable

!

interface Serial2:15

no ip address

isdn switch-type primary-net5

isdn incoming-voice modem

isdn T310 60000

no cdp enable

!

voice-port 1:D

cptone ID

!

voice-port 2:D

cptone ID

!

dial-peer voice 10 voip

destination-pattern T

session target ras

!

dial-peer voice 3 pots

destination-pattern 007T

direct-inward-dial

port 1:D

!

dial-peer voice 4 pots

destination-pattern 007T

direct-inward-dial

port 2:D




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Mon, 06/24/2002 - 14:38
User Badges:

nothing to add, just take out the dial-peer voip, so no incoming calls will be routed and 5300

will fail any incoming calls.



Actions

This Discussion