×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Anonymous (not verified) Mon, 06/24/2002 - 14:38
User Badges:

Procedure Mentioned below is applicable on all IOS versions above 11.3(1)MA1

Procedure:

1. go to enable mode

2. configure terminal

3. change register to 0x0

4. write to memory

5. reload will bring the router into rommon mode

6. type in "trunk E1" then hit Enter (trunk T1 if vise versa)

7. type "confreg 0x2102"

8. type "reset"

9. the router should reboot and change MFT trunk to E1.



Actions

This Discussion