×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Is there any way to map one nat address to multiple addresses

Unanswered Question
Jun 25th, 2002
User Badges:

Basically what I want to do is on one side of the router have a lan that has 2 dns servers that both get nat translated to the same address on the outside so that i could load balance between the two dns servers using the same address. Just wondering if this is possible.


thanks


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
edadios Tue, 06/25/2002 - 15:41
User Badges:
  • Silver, 250 points or more

You should have posted this on the content networking forum(emerging technology). They deal with such technology devices that does what you are after.

Actions

This Discussion