×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Does E1/ISDN-PRI Network Module support QSIQ ?

Unanswered Question
Jun 25th, 2002
User Badges:
  • Bronze, 100 points or more

I need to know if E1/ISDN-PRI Network Module ( NM-1CE1B) on cisco2600 support QSIG Protocol (Basi-Call ECMA 142/143) and if yes what IOS version is required ?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Tue, 06/25/2002 - 09:39
User Badges:


No, you may need to use a Digital T1/E1 Packet Voice trunk Network Module.



Digital T1 and E1 interfaces are available on the Cisco 2600 Series. QSIG signalling is also available currently. You will need to load a PLUS image of Cisco IOS 12007XK to use the digital voice modules with QSIG.



Any Cisco IOS Plus Feature Set at revision 12.0(5)XK or later than 12.0(6)T for T1 and 12007XK or 12101T for E1 and QSIG.



Actions

This Discussion