×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CIDS 4210 - Command and Control IP

Unanswered Question
Jun 26th, 2002
User Badges:

If I was to place a sensor on the DMZ, let's say the 192.168.205.0 segment, do I need to set the command and control interface's IP address to a 192.168.205.x address? What is the best practice in setting this IP address, a DMZ address or internal address? Thanks in advance!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
danrodri Wed, 06/26/2002 - 19:08
User Badges:
  • Cisco Employee,

The best practice is to put the command and control interface on a different network (more secure) than the monitoring.

Actions

This Discussion