×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Reset a line interface on a 26xx router

Unanswered Question
Jun 27th, 2002
User Badges:
  • Bronze, 100 points or more

I have a router 2611 with the Serial module 8S/A which runs the IOS vers. 12.2.7. I configure a line interface associated with it corresponding async interface. For a special reason I have to erase all command line under the line int. It's running fine with the command "default int serialx/x".


I want to do the same thing on a 2620 router with the 16 async ports module and IOS vers 12.2.7. In that situation the result of the "default int asyn x/x" is not it wanted.

Is there a command to completely reset the line interface ?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Thu, 06/27/2002 - 14:12
User Badges:

The default command does not apply to

async-interfaces (as opposed to serial

interfaces set up as async)...


Actions

This Discussion