×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IPSec error Director->Sensor

Unanswered Question
Jul 2nd, 2002
User Badges:

All,

I have a problem that I need some help with. We had a sensor configured,

using IPSec. Someone then changed the org id on the sensor without

removing the IPSec config on the director. I think they also turned off IPSec,

because now I get a lot of errors on my console about non-secure traffic

coming from that source, I can't add the sensor back in the director, and there

is nothing about that host when I check the secure communications info

from sysconfig-director.


So... I thought I might have luck deleting any remnants from the director

using the ipsectool, but I get a warning about the NETRANGER variable being

unset when I try to dump the SA info... HELP!!!!



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Georgia Coalman Sat, 07/06/2002 - 16:09
User Badges:

Could you copy and paste the error messages that you're getting to start off with?

basicitone Wed, 08/14/2002 - 06:24
User Badges:

Just had a similar problem. after a org id change we had to readd sensor to director then redo IPSec keys on sensor and director.

Actions

This Discussion