Call busy signal on VWIC 2B NT/TE

Unanswered Question
Jul 3rd, 2002
User Badges:
  • Bronze, 100 points or more

If a voice call originates in site A and the vxic 2b nt/te on site B is busy, is there any way that the busy port can send back a busy tone to the user on site A.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Wed, 07/03/2002 - 13:46
User Badges:

If you forwarding a call out a ISDN port that is

busy it should send you a no channel available in the disconnect.


If you want to re-route on any failure, however, of play a busytone, you

can configure the isdn interface to send a release cause-code of 11.


So from global mode, use the command "isdn voice-call-failure 11"


The router A would receive this when isdn cause code is release for all reasons except

Normal call clearing, User busy, No user responding




Actions

This Discussion