Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
171
Views
0
Helpful
1
Replies

Call busy signal on VWIC 2B NT/TE

admin_2
Level 3
Level 3

‎07-03-2002 01:46 PM - edited ‎03-12-2019 07:43 PM

If a voice call originates in site A and the vxic 2b nt/te on site B is busy, is there any way that the busy port can send back a busy tone to the user on site A.

Labels:
0 Helpful
1 Reply 1

Not applicable

‎07-03-2002 01:46 PM

If you forwarding a call out a ISDN port that is

busy it should send you a no channel available in the disconnect.

If you want to re-route on any failure, however, of play a busytone, you

can configure the isdn interface to send a release cause-code of 11.

So from global mode, use the command "isdn voice-call-failure 11"

The router A would receive this when isdn cause code is release for all reasons except

Normal call clearing, User busy, No user responding

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents