×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Anonymous (not verified) Wed, 07/03/2002 - 13:46
User Badges:

It is recommended to hard code the frame-relay

addresses using the frame-relay map statement. However,

inverse-arp can typically be used with no problems. Keep

in mind that they do not change dynamically, once

the entries have been established, they remain in the

router unless it is reloaded. If there is a DLCI or IP address

change, it is a good idea to clear this table by using the

clear frame-relay inarp command.



Actions

This Discussion