07-03-2002 01:46 PM - edited 03-01-2019 11:31 PM
I have a 4500 router with a PRI card in it. There are about 15 sites that we can call out through the PRI to. If I have a call up, I have been shutting down the D-channel (s0:23) to disconnect the call. However, if there are 2 calls going on at the same time, then using this method, both calls will be disconnected. How can I disconnect a single call on a PRI without shutting the D-channel down?
07-03-2002 01:46 PM
Try "clear int s0:X", where X is the number of the B channel they're on (not 23).
07-04-2002 12:13 AM
OR
isdn disconnect interface serial 0/0:x all
where x is the interface
Ali
07-04-2002 12:14 AM
oops - connection prob!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: