×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Filtering InterLATA calls based on NPX

Unanswered Question
Jul 15th, 2002
User Badges:

I'm curious how other people are filtering calls based on NPX. I'm running into an issue lately with InterLATA calls and trying to use a route filter to filter calls to different route lists that point to different PRI's in different LATA's.


The issue I keep running into is that I can only add around 6 different clauses in a route filter. Is there an easier way to do this?


Thanks,


Tim


Tim Medley, CCNP+Voice, CCDP, CWNA

Sr. Network Architect

VoIP Group

iReadyWorld

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ciscomoderator Sun, 07/21/2002 - 20:29
User Badges:
  • Gold, 750 points or more

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen


If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.


Actions

This Discussion