×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Catalyst 6000 - switching mode

Unanswered Question
Jul 29th, 2002
User Badges:

Hi,

I woud like to setup switching mode on Catalyst 6000 with CATOS. The default switching mode is "store and forward" and I want to change to "cut through" or "fragment free".


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bradwong Mon, 07/29/2002 - 02:46
User Badges:

This is not possible - most Catalyst-series switches are "store and forward" - with specialised line-card ASICs for frame-forwarding and FCS-checking used in these switches, there is no real advantage in using cut through switching.

Actions

This Discussion