cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
235
Views
0
Helpful
1
Replies

Catalyst 6000 - switching mode

mikulec
Level 1
Level 1

Hi,

I woud like to setup switching mode on Catalyst 6000 with CATOS. The default switching mode is "store and forward" and I want to change to "cut through" or "fragment free".

1 Reply 1

bradwong
Level 1
Level 1

This is not possible - most Catalyst-series switches are "store and forward" - with specialised line-card ASICs for frame-forwarding and FCS-checking used in these switches, there is no real advantage in using cut through switching.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: