×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CDP Error? trying...

Unanswered Question
Aug 5th, 2002
User Badges:

Dear Sir!


Cisco write, that CDP works over FrameRelay (as SNAP-capable link).


But however hard I may try, but I can't see Frame Relay switch by CDP in my lab!


What CDP configuration must I use on my FrameRelay switch?


Best regards,

Nick


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vmiller Mon, 08/05/2002 - 14:14
User Badges:
  • Gold, 750 points or more

It may be disabled on serial interfaces. gointo config mode for the Interface

and try a CDP enable....


hth

mljohnson Mon, 08/05/2002 - 14:18
User Badges:

I assume that the FR switch is a cisco IOS device? If not, this won't work. If it is, make sure that you have recent code on the devices, as there could be bugs (although I don't see any specific bugs right now could apply). In terms of configuration, there isn't a lot to it besides "CDP run" (global) and "cdp enable (per interface).

Actions

This Discussion