08-05-2002 03:57 AM - edited 03-02-2019 12:26 AM
Dear Sir!
Cisco write, that CDP works over FrameRelay (as SNAP-capable link).
But however hard I may try, but I can't see Frame Relay switch by CDP in my lab!
What CDP configuration must I use on my FrameRelay switch?
Best regards,
Nick
08-05-2002 02:14 PM
It may be disabled on serial interfaces. gointo config mode for the Interface
and try a CDP enable....
hth
08-05-2002 02:18 PM
I assume that the FR switch is a cisco IOS device? If not, this won't work. If it is, make sure that you have recent code on the devices, as there could be bugs (although I don't see any specific bugs right now could apply). In terms of configuration, there isn't a lot to it besides "CDP run" (global) and "cdp enable (per interface).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: