08-08-2002 07:09 PM - edited 03-02-2019 12:33 AM
My 7507 router has the following problem,and i don't know that if it was a malfunctioned CI problem or a power supply problem.How can i trouble it?
Accoriding to my previous experience,the CI model in 7507 router is easy to report the +12V voltage at a low level,and there is something wrong with the ci model.
sh log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Console logging: disabled
Monitor logging: level debugging, 0 messages logged
Buffer logging: level debugging, 298 messages logged
Trap logging: level debugging, 307 message lines logged
Logging to 40.112.0.100, 307 message lines logged
--More--
Log Buffer (5000 bytes):
RN: +12 Voltage measured at 11.61
*Aug 1 11:53:56: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 1 13:14:14: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 1 17:36:29: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 1 19:07:47: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 2 07:43:27: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 2 22:07:55: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 3 15:33:02: %CI-4-ENVWARN: +12 Voltage measured at 11.61
*Aug 4 03:06:33: %CI-4-ENVWARN: +12 Voltage measured at 11.61
R2>sh envi
All measured values are normal
R2>sh envi all
Arbiter type 2, backplane type 7507MX (id 4)
Power supply #1 is 700W (id 2), power supply #2 is 700W (id 2)
Active fault conditions: none
Active trip points: none
15 of 15 soft shutdowns remaining before hard shutdown
0123456
Dbus slots: XXX XX
card inlet hotpoint exhaust
RSP(2) 17C/62F 21C/69F 23C/73F
Shutdown temperature source is 'hotpoint' on RSP(2), requested RSP(2)
+12V measured at 11.65
+5V measured at 5.13
-12V measured at -11.89
+24V measured at 22.74
+2.5 reference is 2.47
R2>sh envi ta
Sample Point LowCritical LowWarning HighWarning HighCritical
RSP(2) Inlet 44C/111F 50C/122F
RSP(2) Hotpoint 54C/129F 60C/140F
RSP(2) Exhaust
RSP(3) Inlet 44C/111F 50C/122F
RSP(3) Hotpoint 54C/129F 60C/140F
RSP(3) Exhaust
+12 Voltage 10.90 11.61 12.82 13.38
+5 Voltage 4.61 4.94 5.46 5.70
-12 Voltage -10.15 -10.76 -13.25 -13.86
+24 Voltage 20.38 21.51 26.42 27.65
2.5 Reference 2.43 2.51
Shutdown boards at 70C/158F
Shutdown power supplies at 76C/168F
Restart after shutdown below 40C/104F
R2>sh envi last
RSP(2) Inlet previously measured at 15C/59F
RSP(2) Hotpoint previously measured at 19C/66F
RSP(2) Exhaust previously measured at 21C/69F
+12 Voltage previously measured at 11.70
+5 Voltage previously measured at 5.13
-12 Voltage previously measured at -11.89
+24 Voltage previously measured at 22.74
08-19-2002 01:05 PM
You'll probably want to contact your tac engineers on this one.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: