×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco 2621 doesn't recognize 1-port ADSL WIC

Unanswered Question
Aug 10th, 2002
User Badges:

Running IOS 12.2(6r). Installed WIC mentioned above in slot W0. Slot W1 is empty.

I went through initial configuration and set up FastEthernet0/0 and 0/1.

It doesn't seem to recognize the WIC at all and there are no lights.

I tried bringing it up using INTERFACE ATM.

Still nothing.

I'm not sure if the ADSL line is active but would the card still not be recognized?

Obviously I'm a bit new to routers.

TIA


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Sat, 08/10/2002 - 10:12
User Badges:
  • Cisco Employee,

For 2600, WIC-1ADSL first supported in Cisco IOS Release 12.1(5)YB - now supported in Cisco IOS Releases 12.2(4)T, 12.2(2)XK, 12.2(4)XL onwards..and Requires a Cisco IOS "Plus" image..


Pl. locate "ios and paltform support" section on following url for more information

http://www.cisco.com/warp/public/cc/pd/rt/2600/prodlit/a2636_ds.htm


So download any of above image or later with PLUS featureset..to fix the problem.

Actions

This Discussion