×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

DSL config without dialer ? to notice Link down

Unanswered Question
Aug 18th, 2002
User Badges:

Is it possible to make a DSL configuration (where you normally would use a dialer interface) ?

Reason: We would like to trigger a isdn call, when the DSL link goes down.

So I prefer monitoring the Atm interface with a "standby" command.

Is this possible ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Sat, 08/24/2002 - 19:49
User Badges:
  • Cisco Employee,

It depends on the line configuration for dsl line..For PPP related line like PPPoA and PPPoE you do need dialer interface as it supports "encap ppp" command...For RFC 1483 bridging or RBE line you can get away with atm interface config only..

Backing up dsl line using "dialer interface" is always a tricky, you need to use "floating static route"..Just a thought..Tejal

Actions

This Discussion