08-19-2002 04:49 PM - edited 03-12-2019 08:24 PM
I have a VG200 with a DSP farm module that I cannot seem to get running. I've got all the necessary SCCP commands in the unit but when I do a "show dspfarm", I see this:
DSPFARM Configuration Information:
Admin State: UP, Oper Status: DOWN - Cause code: DSPWARE_NOT_UP
Transcoding Sessions: 0, Conferencing Sessions: 15
Trans sessions for mixed-mode conf: 0, RTP Timeout: 600
Connection check interval 600, Codec G729 VAD: DISABLED
I did a search for DSPWARE_NOT_UP on CCO and the NPF but could not find anything . I am running 12.1(5)YH4 code. Any ideas on what would cause this?
08-20-2002 05:49 AM
You may need to do a 'no shut' under the dspfarm interface. If this does not bring it up, please open a TAC case.
08-20-2002 10:44 AM
I had a similar problem recently. I found that I had provisioned the max number of conference and transcoder sessions beyond the number of possible sessions installed on the DSP farm. I thought there were 2 simms installed in the farm when there was only 1. As soon as I adjusted the max paramaters the "sh dspfarm" output looked normal.
Hope this helps.
Bob Evans
CCIE 7998
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: