×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Access Control Question

Unanswered Question
Aug 20th, 2002
User Badges:

I want to be able to set a Client up to be able to telnet into a 2950 Switch and be able to do only interface level configuring on a switchport. I do not want them to have conifig privilages. I looked on CCO and all it says is to give that level of access spacific commands that it can do but I can get it to work. Is this possible?


Any help would be appreciated. Thanks


Here's what I did:

enable password level 2 cisco

privilege exec level 2 config

privilege interface level 2 interface fast ethernet

privilege interface level 2 speed

privilege interface level 2 duplex

privilege interface level 2 shut

privilege interface level 2 no shut




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion