cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
479
Views
0
Helpful
1
Replies

AP 350 Series Routing

Cintifacts
Level 1
Level 1

Is there a way to use the wireless signal obtained by the access point (in this case a repeater) and route it to a wired network or the ethernet port on the access point itself? I know there is a routing option under "Services" on the Access Point but I wanted to make sure this was possible before I made any configurations.

Thank you,

David

kil.5@nd.edu

1 Reply 1

tepatel
Cisco Employee
Cisco Employee

In case of access point acting as a "Repeater" ethernet port of that "Repeater" will be disabled..So You can't communicate with the wired LAN on Repeater over the wireless link.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: