×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

1200 password recovery

Unanswered Question
Aug 28th, 2002
User Badges:

hello

I can't give out the :resetall command because the AP ask for the username & password first......How can i do real password recovery that works?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Wed, 08/28/2002 - 10:28
User Badges:
  • Cisco Employee,

The :resetall command is valid for only 2 minutes immediately after the AP reboots..You need to enter that command immediately after Summary Status screen appears..That way It should not ask for authentication..Here is the procedure documented on cco

http://www.cisco.com/warp/public/102/wlan/pwrec-2.html#resetap

If you still can't get it working, you might want to open a case for that issue with TAC at http://www.cisco.com/tac

s.matyas Mon, 09/02/2002 - 03:47
User Badges:

Hello,


I think I can't understand something clear .I can not allow read only browsing......therefore I can do nothing before I write the correct username/password. What can I do in this situation?


Actions

This Discussion