×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Catalyst 6500 question

Unanswered Question
Aug 28th, 2002
User Badges:

I'm working on a catalyst 6500 and trying to set up the VLANs on it. I session into MSFC and go to "Router (config)#". However from there "ip routing" command is not available to enable the routing. Any idea?


Thanx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Prashanth Krishnappa Wed, 08/28/2002 - 19:21
User Badges:
  • Cisco Employee,

I tried it in the lab switch and I do see the command. Is your MSFC in boot mode? Can you paste output of show version

Router(config)#ip ro?

route routing


Router(config)#ip routin

Router(config)#ip routing

Router(config)#

kendo.igor Wed, 08/28/2002 - 19:33
User Badges:

Yes. It is in the boot mode. How do I get out of it?


Thanx.

Prashanth Krishnappa Wed, 08/28/2002 - 19:41
User Badges:
  • Cisco Employee,

do a "dir bootflash:" and see if you have a valid IOS file. If you do, set a boot variable using the following commands

conf terminal

boot system flash bootflash:

config-register 0x2102

end

wr mem

reload

Actions

This Discussion