Configuring nat on a single interface

Unanswered Question
Aug 30th, 2002

I have a 2524 router that I am trying to adapt for a customers network. I have a DSL modem with a static ip connecting into a hub. The router only has one ethernet port. I would like to perform a nat operation if at all possible to translate between the static ip and the internal private ip. Is there a way to do this? Right now I have the static on e0 and the private on e0 secondary.

I am using IOS 12.0 ip plus/fw.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
flugel_1 Tue, 09/03/2002 - 11:30

Secondary doesn't work but I get the eror message that you must be running ISL or 802.11Q to have a subinterface on a ethernet port. Is it possible to act like you are running VLANs without running VLANs.


This Discussion