×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VPN Client 3.6 : only ping work

Unanswered Question

Hi,


I have a cisco 806 router configure to enable VPN connection.


When i test a connection with a Windows 2000 or Windows XP (Cisco VPN 3.6) i can connect to the enterprise network.


Ping hosts inside the network is OK, but when i want to use an application like VNC Viewer, a Cute FTP, or net use command, the connection failed.


Does anyone have solutions ?


( Configuration client VPN 3.6

Enable transparent tunneling

and allow Ipsec over UDP


If i check allow ipsec over TCP, i can't connect


Thanks for your help


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
bderry Wed, 09/11/2002 - 04:57
User Badges:

I'm assuming your connecting through the 806 and not to it.


I had the same problem to, except I was connecting to a VPN 3005 Concentrator. I found that it was the MTU fragmentation setting that I had to adjust to get it to work. If your connecting to the 806 then check to see if there is a setting that is related to fragment before IPSEC encapsulation. That is what I had to change to get it to work.


Hope this helps,

Ben

Actions

This Discussion