09-03-2002 10:02 PM - edited 03-02-2019 01:06 AM
Why can't I assign encapsulation to e0.1 on a Cisco 2503 router? I have loaded 12.2.11T ip plus IOS. this is later than the recommended 13.1.3T in the available documentation.
please help
Dr Kevin.L.Schoevers
Senior Engineer
NSC
09-03-2002 10:30 PM
i think dot1q encapsulation works only for FastEthernet interfaces
rgds,
mart
09-03-2002 10:43 PM
Matt, they allowed encapsulation on the ethernet ports on a 2611 (these are not fast ethernet). THanks for answering though.
regards
Schooner
09-03-2002 11:41 PM
Hi,
If memory serves me correcltly the actual dot1q encaps is done in H/W and thus dependant on chipsets present.
I know the following devices support it plus the new RSP16:
Cisco 1710, Cisco 1751, 2600 series, 3600 series,Cisco 4000-M series (Cisco 4000-M, 4500-M, 4700-M), Cisco 7200 series ,RSP1Cisco 7505, RSP2 on7507 and 7513.
Regards
Dale
RSP4Cisco 7505, Cisco 7507, Cisco 7513, and Cisco 7576
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: