×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cant get 3rd interface to be seen on PIX 515

Unanswered Question
Sep 10th, 2002
User Badges:

Here is the info from Sh Ver


Hardware: PIX-515, 32 MB RAM, CPU Pentium 200 MHz

Flash i28F640J5 @ 0x300, 16MB

BIOS Flash AT29C257 @ 0xfffd8000, 32KB


0: ethernet0: address is 0050.54fe.ef68, irq 10

1: ethernet1: address is 0050.54fe.ef69, irq 7

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES: Disabled

Maximum Interfaces: 3

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Unlimited

IKE peers: Unlimited


Serial Number: 403480639 (0x180ca03f)




Its as though the Card is not installed. Its in there. Does it matter what slot it is in??


Thanks,

Scott<-

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
steve.barlow Wed, 09/11/2002 - 06:11
User Badges:
  • Silver, 250 points or more

Did you install it in the top slot? If no, place it there. It's not a gig card is it - they aren't supported in 515s.


Steve

Actions

This Discussion