10-03-2002 02:45 AM - edited 03-02-2019 01:48 AM
Hi,
I have two Ciso switches (but different IOS version 12.0 & 12.1). I want to connect them by EtherChannel. However, the command setting is difference as follows:
In 12.1, the setting is as follows:
int port channel 1
switch mode trunk
int fast 0/24
switch mode trunk
channel-group 1 mode on
int fast 0/25
switch mode trunk
channel-group 1 mode on
In 12.0,
int fast 0/24
switch mode trunk
port group 1 distribution destination
int fast 0/25
switch mode trunk
port group 1 distribution destination
Does this setting work ? If not, any other way to set.
Pls advise. Thanks.
10-03-2002 07:58 AM
It should work..Are you having any issues?. Let us know what model switches are these and full software versions you are running
10-03-2002 07:27 PM
When I tried the setting, I found that port channel was not work. Instead, the spanning tree protocol was used.
Both are Cisco2950C while one IOS is 12.1(6)EAC and another is 12.0(5.3)WC1.
Are those EtherChannel commands compatible ?
10-03-2002 08:01 PM
Try removing all the config under the interfaces in question, configure the channel with default "source" forwarding method and if this comes up fine trunk over it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide